🔧 Fit - Front Windshield Wiper Blade Replacement

Your Fit uses two different-size front wiper blades. Each blade releases from its J-hook-style arm, then the new blade slides and locks into place.

Difficulty Level: Beginner | Estimated Time: 10-15 minutes

---

⚠️ Safety & Precautions

• ⚠️ Switch the ignition off before touching the wiper arms.
• 🛡️ Protect the windshield with a folded towel because the bare metal arm can crack the glass if it snaps down.
• ✋ Replace one blade at a time so the blade positions cannot be mixed up.
• 🔋 Battery disconnection is not required.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Microfiber towel (folded)
• Nitrile work gloves
• Safety glasses

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Driver-side front wiper blade (28-inch) - Qty: 1
• Passenger-side front wiper blade (14-inch) - Qty: 1

Replace both front blades together for even wiping performance.

---

📋 Before You Begin

• 🚗 Park your Fit on level ground and engage the parking brake.
• 🔑 Turn the ignition completely off and remove the key.
• 🌤️ Clean heavy dirt from the windshield before installing the new blades.
• 📏 Match each new blade to the corresponding old blade before removing anything.
• 📱 No infotainment menu, scan tool, coding, or service mode is required.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Protect the Windshield

• Put on the nitrile work gloves and safety glasses.
• Use the microfiber towel to cover the glass directly below the driver-side wiper arm.
• The towel cushions the glass if the spring-loaded arm slips.

Step 2: Raise the Driver-Side Wiper Arm

• Use your gloved hand to lift the 28-inch driver-side arm away from the windshield.
• Hold the metal arm securely while working. Do not release it without a blade attached.

Step 3: Release the Driver-Side Blade

• Rotate the blade until it sits nearly perpendicular to the metal arm.
• Locate the small locking tab where the blade connects to the curved J-shaped hook.
• Use your gloved thumb to press the locking tab.
• While holding the tab, slide the blade downward toward the base of the wiper arm.
• Guide the blade around and off the hook.
• Do not force the plastic connector.

Step 4: Install the New Driver-Side Blade

• Use your gloved hands to feed the arm's J-hook through the opening in the new 28-inch blade connector.
• Slide the blade upward along the hook until the connector clicks into place.
• Gently pull the blade downward to verify that the lock is engaged.
• Use your gloved hand to lower the arm slowly onto the windshield.

Step 5: Replace the Passenger-Side Blade

• Move the microfiber towel beneath the passenger-side wiper arm.
• Use your gloved hand to lift the arm and rotate the 14-inch blade.
• Press the connector tab, slide the old blade toward the arm base, and guide it off the J-hook.
• Slide the new 14-inch blade onto the hook until it clicks.
• Pull gently to verify the lock, then lower the arm carefully.

Step 6: Inspect the Installation

• Use your gloved hands to confirm both rubber wiping edges lie flat against the glass.
• Verify the 28-inch blade is on the driver side and the 14-inch blade is on the passenger side.
• Remove the microfiber towel before operating the wipers.

---

✅ After Repair

• 💧 Apply windshield washer fluid and operate the wipers at low speed.
• 👀 Confirm both blades move freely without striking each other or the windshield trim.
• ✨ Check for streaking, chatter, or unwiped areas. Recheck the connector if a blade sits unevenly.
• 🛑 Stop the wipers immediately if either blade becomes loose.

---

💰 DIY vs Shop Cost

Shop Cost: ₹1,800-₹4,500 (parts + installation)

DIY Cost: ₹1,200-₹3,000 (parts only)

You Save: ₹600-₹1,500 by doing it yourself!

Local labor and imported blade prices vary. This repair takes a shop approximately 0.1-0.3 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.